There are ten videos in this series ranging from 3 to just over 14 minutes covering all the steps necessary to develop a based, articulated, sectioned, and trimmed set of working models made to the Pro-Model" Standards. It includes an introduction comparing and contrasting various types of articulation and ways to make models removable from articulators to ease use.

The segments can be viewed individually, easily paused or rewound and progress in logical steps through a clearly defined process. Important points are frequently detailed at the start of a step and most procedures are accompanied by clear reasons for proceeding in a particular way. It would be very easy to watch the segments one at a time, proceed through the step by step techniques and produce a properly based and articulated Pro-Model" by the end. The segments also include brand names of materials and equipment used to allow the viewer to follow up on items of interest. The following paragraphs describe the contents of each of the segments.

Videos in this series:
Introduction to the Fixed Cast Pro-Model" 3:00 min
Base Mold Selection 4:35 min
Mix and Pour Base 11:45 min
Trimming the Pro-Model" 9:25 min
The Opposing Model 6:20 min
The Orbix Articulator 10:00 min
Prepare to Cut Die Sections 4:15 min
Cut The Die Sections 12:45 min
Prepare to Contour Die Stems 5:00 min
Contour Die Stems 14:10 min

Full Length Running Time: 1hr 25 min

Video approved for 1.5 Scientific credits from the NBC

NADL Members - Be sure to enter your promotional coupon code at check out to get your 15% NADL Member discount. Not sure of the NADL Member promotional coupon code? Contact nadl@nadl.org or log into the NADL Benefits Page.

CDTs/RGs - Be sure to enter your promotional coupon code at check out to get your 5% CDT/RG discount. Not sure of the CDT/RG promotional coupon code? Contact nadl@nadl.org or log into your MyNBC page.